No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


Configuration Guide - VPN

S9300, S9300E, and S9300X V200R010C00

This document describes the VPN configuration procedures and provides configuration examples.

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Binding a VPN Instance to an Interface

Binding a VPN Instance to an Interface


A VPN instance has been created and the IPv4 address family has been enabled for the VPN instance.


  • After configuring a VPN instance on a PE device, bind the VPN instance to the interface that belongs to the VPN. Otherwise, the interface functions as a public network interface and cannot forward VPN data.
  • An interface becomes a private network interface after a VPN instance is bound to it. You must configure an IP address for the interface so that the PE device can exchange routing information with its attached CE device.
  • After a VPN instance is bound to an interface, configuration of the Layer 3 features (IPv4 and IPv6 features) including IP addresses and routing protocols is deleted from the interface.
  • When you disable an address family (IPv4 or IPv6 address family) in a VPN instance, configuration of the address family is deleted from the interface. No interface is bound to a VPN instance if no address family configuration exists in the VPN instance.

Perform the following steps on the PE devices.


  1. Run:


    The system view is displayed.

  2. Run:

    interface interface-type interface-number

    The interface view is displayed.

  3. (Optional) On an Ethernet interface, run undo portswitch

    The interface is switched to Layer 3 mode.

    By default, an Ethernet interface works in Layer 2 mode.

  4. Run:

    ip binding vpn-instance vpn-instance-name

    A VPN instance is bound to the interface.

    By default, an interface is a public network interface and is not associated with any VPN instance.

  5. Run:

    ip address ip-address { mask | mask-length }

    An IP address is configured for the interface.

Updated: 2019-12-31

Document ID: EDOC1000142068

Views: 130929

Downloads: 220

Average rating:
This Document Applies to these Products

Related Version

Related Documents

Previous Next