No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


Configuration Guide - VPN

S9300, S9300E, and S9300X V200R010C00

This document describes the VPN configuration procedures and provides configuration examples.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring a UPE to Access an SPE Through a Static VLL

Configuring a UPE to Access an SPE Through a Static VLL


Perform the following steps on the UPE:


  1. Run:


    The system view is displayed.

  2. Run:

    interface interface-type interface-number

    The interface view is displayed.

  3. (Optional) Run:

    undo portswitch

    The Layer 2 interface is configured as a Layer 3 interface.

    To use an XGE interface, a GE interface, a 40GE interface, a 100GE interface, an Ethernet interface, or an Eth-Trunk interface of the device as the AC interface of the PE, run the undo portswitch command to change a Layer 2 interface to a Layer 3 interface.

  4. Run:

    mpls static-l2vc destination ip-address transmit-vpn-label transmit-label-value receive-vpn-label receive-label-value [ tunnel-policy tnl-policy-name | [ control-word | no-control-word ] | [ raw | tagged ] ] *

    A static VC connection between the UPE and the SPE is established.

Updated: 2019-08-21

Document ID: EDOC1000142068

Views: 111512

Downloads: 204

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Previous Next