No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


Configuration Guide - VPN

S9300, S9300E, and S9300X V200R010C00

This document describes the VPN configuration procedures and provides configuration examples.

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Checking the Configuration

Checking the Configuration


After you configure a hierarchical virtual private network (HVPN), you can view on a local customer edge device (CE) the default route or specific routes from this CE to a remote CE.


  • Run the display ip routing-table command on a local CE to check routing table information.

    • If you have configured an HoVPN, the command output shows a default route from the local CE to the remote CE. The next hop of the route is a user-end provider edge device (UPE).

    • If you have configured an H-VPN, the command output shows specific routes from the local CE to the remote CE.

Updated: 2019-12-31

Document ID: EDOC1000142068

Views: 130560

Downloads: 220

Average rating:
This Document Applies to these Products

Related Version

Related Documents

Previous Next