No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


Configuration Guide - VPN

S9300, S9300E, and S9300X V200R010C00

This document describes the VPN configuration procedures and provides configuration examples.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Checking the Configuration

Checking the Configuration


All configurations of static VLLs to access a VPLS network are complete.


  • Run the display mpls static-l2vc [ interface interface-type interface-number ] command to check information about the static VC configured on the switch.
  • Run the display l2vpn ccc-interface vc-type static-vc up command to check information about VC interfaces in SVC mode in Up state.
  • Run the display vsi [ name vsi-name ] [ verbose ] command to check information about a VPLS VSI.
  • Run the display vsi remote ldp [ router-id ip-address ] [ pw-id pw-id ] command to check information about a remote VSI.
  • Run the display vpls connection [ ldp | vsi vsi-name ] [ down | up ] [ verbose ] command to check information about a VPLS connection.
  • Run the display mac-address dynamic slot-id command to check dynamic MAC address entries.
Updated: 2019-08-21

Document ID: EDOC1000142068

Views: 119614

Downloads: 212

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Previous Next