No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - VPN

S9300, S9300E, and S9300X V200R010C00

This document describes the VPN configuration procedures and provides configuration examples.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Binding an Interface to the VPN Instance

Binding an Interface to the VPN Instance

Context

The configuration on the Hub-PE involves two interfaces or sub-interfaces: one is bound to the VPN-in and receives the routes advertised by the Spoke-PE; the other is bound with the VPN-out and advertises the routes of the Hub and all the Spokes.

  • After configuring a VPN instance on a PE, bind the interface that belongs to the VPN to the VPN instance. If the interface belonging to the VPN is not bound to the VPN instance, the interface functions as a public network interface and cannot forward VPN data.
  • An interface becomes a private network interface after being bound to a VPN instance. You must configure an IP address for the interface so that the PE can exchange routing information with its connected CE.
  • After an interface is bound to a VPN instance, configuration of Layer 3 features (IPv4 and IPv6 features) including IP addresses and routing protocols is deleted from the interface.
  • When you disable an address family (IPv4 or IPv6 address family) in a VPN instance, the address family is deleted from the interface. If no address family is configured on the interface, the interface is unbound from the VPN instance.

Perform the following steps on the Hub-PE and all the Spoke-PEs.

Procedure

  1. Run:

    system-view

    The system view is displayed.

  2. Run:

    interface interface-type interface-number

    The view of the interface to be bound to a VPN instance is displayed.

  3. (Optional) On an Ethernet interface, run undo portswitch

    The interface is switched to Layer 3 mode.

    By default, an Ethernet interface works in Layer 2 mode.

  4. Run:

    ip binding vpn-instance vpn-instance-name

    The interface is bound to the VPN instance.

  5. Run:

    ipv6 enable

    IPv6 is enabled on the interface.

    private network interface

  6. Run:

    ipv6 address { ipv6-address prefix-length | ipv6-address/prefix-length }

    An IPv6 address is configured for the interface.

    Some Layer 3 features such as route exchange between the PE and CE can be configured only after an IPv6 address is configured for the private network interface on the PE.

Translation
Download
Updated: 2019-08-21

Document ID: EDOC1000142068

Views: 111831

Downloads: 204

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next