No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - VPN

S9300, S9300E, and S9300X V200R010C00

This document describes the VPN configuration procedures and provides configuration examples.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Setting Common Parameters for a VSI

Setting Common Parameters for a VSI

Context

Common parameters of a VSI include VPLS encapsulation type of a VSI, MTU for negotiation, tunnel policy for a VSI, and VSI description.

Perform the following steps on PEs at both ends of a PW.

Procedure

  1. Run:

    system-view

    The system view is displayed.

  2. Run:

    vsi vsi-name [ auto | static ]

    The VSI view is displayed.

  3. (Optional) Run:

    mtu mtu-value

    The MTU for packets sent by the VSI is configured.

    The default value of MTU in the VSI view is 1500.

    When configuring MTUs, note that MTUs of VSIs created for the same VPLS on different PEs must be the same.

    NOTE:

    When an interface is bound to a VSI, the MTU can be configured in the interface view but does not take effect. The PW signaling uses the MTU that is configured in the VSI for PW MTU negotiation.

    On the switch, the MTU value is used only for signaling negotiation and does not limit the size of forwarded packets.

  4. (Optional) Run:

    tnl-policy policy-name

    Tunnel policies for a VSI are configured.

    By default, no tunnel policy is applied to a VSI.

  5. (Optional) Run:

    description description

    The VSI description is configured.

    By default, the description of a VSI is empty.

    VSI descriptions help identify different VSIs and describe the functions of VSIs.

Translation
Download
Updated: 2019-08-21

Document ID: EDOC1000142068

Views: 119730

Downloads: 212

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Share
Previous Next