No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


Configuration Guide - VPN

S9300, S9300E, and S9300X V200R010C00

This document describes the VPN configuration procedures and provides configuration examples.

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).



Pseudo-Wire Emulation Edge to Edge (PWE3) is a point-to-point (P2P) technology that transmits Layer 2 services on a multiprotocol label switching Layer 2 virtual private network (MPLS L2VPN). PWE3 simulates essential attributes of a service such as Asynchronous Transfer Mode (ATM), Frame Relay (FR), Ethernet, low-speed Time Division Multiplexing (TDM) circuit, Synchronous Optical Network (SONET), and Synchronous Digital Hierarchy (SDH) on a Packet Switched Network (PSN).


The IP network has developed rapidly in recent years because of its flexibility to upgrade, scalability, and interoperability. Conversely, the traditional communications network has low flexibility because it is limited by the transmission mode and services. To make full use of existing or public network resources during upgrade and expansion of the traditional communications network, PWE3 can be used to integrate the traditional communications network and PSN.

PWE3 often applies to broadband metro access networks (MAN) or mobile bearer networks to transmit various services including Ethernet, ATM, TDM, FR, and PPP. As shown in Figure 5-1, the headquarters of company A and its branch are located on a traditional communications network such as ATM or FR. PWE3 is used to establish a PW between PE1 and PE2 so that the headquarters of company A and its branch can communicate over the MPLS network. PWE3 integrates original access modes with the existing IP backbone network to reduce repetitious network construction, saving operation costs.

Figure 5-1  PWE3 networking

PWE3 allows various services to be transmitted and supports migration from the mobile network to Long Term Evolution (LTE). PWE3 protects carrier investments when ATM and TDM services are migrated to the IP network.

Updated: 2019-12-31

Document ID: EDOC1000142068

Views: 130540

Downloads: 220

Average rating:
This Document Applies to these Products

Related Version

Related Documents

Previous Next