No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


Configuration Guide - VPN

S9300, S9300E, and S9300X V200R010C00

This document describes the VPN configuration procedures and provides configuration examples.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Default Configuration

Default Configuration

Table 6-10  Default configuration of VPLS
Parameter Default Setting
MTU value in the VSI view 1500
Capability of BGP peers in exchanging VPLS member information Disabled
Broadcast traffic suppression in the VSI Disabled
Multicast traffic suppression in the VSI Disabled
Unknown unicast traffic suppression in the VSI Disabled
LDP MAC Withdraw message sent by the VSI Disabled
Encapsulation type of an interface in the VSI view VLAN
MAC diagnosis test Enabled
MAC address learning of a VSI Enabled
L2VPN OAM detection on the PSN tunnel Disabled
PW attributes of the BGP AD VSI Hub
Statistics about the public network traffic on a specified Martini VPLS PW Disabled
Updated: 2019-08-21

Document ID: EDOC1000142068

Views: 115426

Downloads: 210

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Previous Next