No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


Configuration Guide - VPN

S9300, S9300E, and S9300X V200R010C00

This document describes the VPN configuration procedures and provides configuration examples.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Checking the Configuration

Checking the Configuration


All LDP HVPLS configurations are complete.


  • Run the display vsi [ name vsi-name ] [ verbose ] command to check information about a VPLS VSI.
  • Run the display vsi pw out-interface [ vsi vsi-name ] command to check information about the outgoing interface of a PW in a VSI.
  • Run the display l2vpn vsi-list tunnel-policy policy-name command to check information about the tunnel policy applied to a VSI.
  • Run the display vsi remote ldp [ router-id ip-address ] [ pw-id pw-id ] command to check information about a remote VSI.
Updated: 2019-08-21

Document ID: EDOC1000142068

Views: 113161

Downloads: 208

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Previous Next