No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - VPN

S9300, S9300E, and S9300X V200R010C00

This document describes the VPN configuration procedures and provides configuration examples.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring MP-IBGP Between PEs and ASBRs in the Same AS

Configuring MP-IBGP Between PEs and ASBRs in the Same AS

Context

Perform the following steps on the PE and ASBR in the same AS.

Procedure

  1. Run

    system-view

    The system view is displayed.

  2. Run:

    bgp { as-number-plain | as-number-dot }

    The BGP view is displayed.

  3. Run

    peer ipv4-address as-number as-number

    The peer ASBR is specified as the IBGP peer.

  4. Run

    peer ipv4-address connect-interface loopback interface-number

    The address of the loopback interface is specified as the source address of the BGP session.

  5. Run

    ipv6-family vpnv6

    The BGP IPv6 VPN address family view is displayed.

  6. Run

    peer ipv4-address enable

    The exchange of VPN-IPv6 routes with the peer PE or the ASBR is enabled.

Translation
Download
Updated: 2019-08-21

Document ID: EDOC1000142068

Views: 112898

Downloads: 208

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Share
Previous Next