No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - VPN

S9300, S9300E, and S9300X V200R010C00

This document describes the VPN configuration procedures and provides configuration examples.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Control Word

Control Word

The Control Word is negotiated at the control plane, and is used for packet sequence detection, packet fragmentation, and packet reassembly at the forwarding plane. In the PWE3 protocols, ATM Adaptation Layer Type 5 (AAL5) requires support for the CW. The negotiation of the CW at the control plane is simple. If the CW is supported after the negotiation, the negotiation result needs to be delivered to the forwarding module, which detects the packet sequence and reassembles the packet.

The CW is a 4-byte encapsulated packet header, as shown in Figure 5-7. It is used to transmit packets on an MPLS packet switched network (PSN).

Figure 5-7  Position of the CW in a packet

The CW has the following functions:

  • Carries the sequence number for forwarding packets.

    If the forwarding plane supports the CW, a 32-bit CW is added before the data packet to indicate the packet sequence. When load balancing is supported, the packets may be out of sequence. The CW can be used to number the packets so that the peer can reassemble the packets.

  • Pads the packets to prevent the packets from being too short.

    For example, if two PEs connect to each other over an Ethernet and CEs connect to PEs over PPP links, PPP negotiation cannot succeed because the size of PPP control packets cannot meet the minimum MTU requirements of an Ethernet. To prevent this problem, you can pad the CW as padding bits to the PPP control packet.

  • Carries the control information of the Layer 2 frame header.

    In certain cases, the frame does not need to be transmitted completely in the L2VPN packets on the network. The frame header is stripped at the ingress and added at the egress. This method, however, cannot be used if the information in the frame header needs to be carried. You can use the CW to solve this problem. The CW can carry the negotiated information between the ingress PE and the egress PE.

At the control plane, the negotiation succeeds only when both ends or neither end supports the CW. At the forwarding plane, the negotiation result at the control plane determines whether the CW is added to a packet.

Translation
Download
Updated: 2019-08-21

Document ID: EDOC1000142068

Views: 112310

Downloads: 208

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next