No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


Configuration Guide - VPN

S9300, S9300E, and S9300X V200R010C00

This document describes the VPN configuration procedures and provides configuration examples.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Establishing MP-IBGP Peer Relationships Between PE Devices

Establishing MP-IBGP Peer Relationships Between PE Devices


Perform the following steps on the PE devices.


  1. Run:


    The system view is displayed.

  2. Run:

    bgp { as-number-plain | as-number-dot }

    The BGP view is displayed.

  3. Run:

    peer ipv4-address as-number as-number

    The peer PE is configured as a BGP peer.

  4. Run:

    peer ipv4-address connect-interface loopback interface-number

    An interface is used to set up a Transmission Control Protocol (TCP) connection with the BGP peer.


    A PE must use a loopback interface address with a 32-bit mask to set up an MP-IBGP peer relationship with the peer PE so that VPN routes can be iterated to tunnels. The route to the local loopback interface is advertised to the peer PE using an IGP on the MPLS backbone network.

  5. Run:

    ipv4-family vpnv4 [ unicast ]

    The BGP-VPNv4 address family view is displayed.

  6. Run:

    peer ipv4-address enable

    The ability to exchange VPN IPv4 routes with the BGP peer is enabled.

Related Tasks

When a large number of PE devices on the backbone network need to establish MP-IBGP peer relationships to exchange VPN routes, configure a route reflector (RR) to reduce the number of MP-IBGP connections between PE devices. The PE devices only need to establish MP-IBGP peer relationships with the RR. For detailed configuration, see Configuring Route Reflection to Optimize the VPN Backbone Layer.

Updated: 2019-08-21

Document ID: EDOC1000142068

Views: 121165

Downloads: 214

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Previous Next