No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


Configuration Guide - VPN

S9300, S9300E, and S9300X V200R010C00

This document describes the VPN configuration procedures and provides configuration examples.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Enabling MPLS L2VPN

Enabling MPLS L2VPN


Before configuring a PW, you must enable MPLS L2VPN.

Perform the following operations on the PEs or UPEs at both ends of a PW.


  1. Run:


    The system view is displayed.

  2. Run:

    mpls l2vpn

    MPLS L2VPN is enabled.


    If the non-Huawei device does not have the capability of processing L2VPN label requests, you need to run the mpls l2vpn no-request-message command on the Huawei device to enable the two devices to communicate.

Updated: 2019-08-21

Document ID: EDOC1000142068

Views: 112401

Downloads: 208

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Previous Next