No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


Configuration Guide - VPN

S9300, S9300E, and S9300X V200R010C00

This document describes the VPN configuration procedures and provides configuration examples.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring BGP AD VPLS

Configuring BGP AD VPLS

Pre-configuration Task

BGP AD VPLS uses BGP packets to implement VSI discovery and uses the LDP FEC 129 signaling to establish PWs to implement VPLS PW automatic establishment.

Before configuring BGP AD VPLS, complete the following tasks:
  • Configure LSR IDs and enabling MPLS on PEs and Ps.
  • Enable MPLS L2VPN on PEs.
  • Establish tunnels between PEs for data transmission.

Configuration Process

To configure BGP AD VPLS, perform the following configurations on PEs at both ends of a PW.

Updated: 2019-08-21

Document ID: EDOC1000142068

Views: 120630

Downloads: 214

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Previous Next