No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - VPN

S9300, S9300E, and S9300X V200R010C00

This document describes the VPN configuration procedures and provides configuration examples.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Enabling the BGP Peer to Exchange VPLS Information

Enabling the BGP Peer to Exchange VPLS Information

Context

BGP VPLS shares the TCP connection with the common BGP protocol. Therefore, most BGP VPLS configurations are the same as the configurations of the common BGP protocol. Nevertheless, VPLS label blocks need to be exchanged in BGP VPLS. Therefore, you need to enable peers to exchange VPLS label blocks in the BGP VPLS address family view.

Please do as follows on the PEs of the two ends of the PW:

Procedure

  1. Run:

    system-view

    The system view is displayed.

  2. Run:

    bgp { as-number-plain | as-number-dot }

    The BGP view is displayed.

  3. Run:

    peer ipv4-address as-number as-number

    The BGP peer is configured.

  4. Run:

    peer ipv4-address connect-interface loopback interface-number

    The interface used to set up the TCP connection is specified.

    NOTE:

    To improve reliability, on the PE, the local loopback interface is generally specified as the interface to set up the TCP connection.

  5. Configure the Kompella VPLS signaling capability:

    Kompella VPLS can use either the BGP-VPLS address family or the BGP-L2VPN-AD address family. You can use either of the following methods to configure the Kompella VPLS signaling capability. Method 1 is recommended.

    • Method 1

      1. Run:

        l2vpn-ad-family

        The L2VPN-AD address family view is displayed.

      2. Run:

        peer ipv4-address enable

        A peer is specified, and the function to exchange route information with the specified peer is enabled.

        After you specify a peer in the L2VPN-AD address family view, the BGP AD signaling capability is enabled by default.

      3. Run:

        signaling vpls
        or
        peer ip-address signaling vpls

        The Kompella VPLS signaling capability is enabled.

      4. (Optional) Run:

        signaling vpls-ad disable

        The BGP AD signaling capability is disabled.

    • Method 2

      1. Run:

        vpls-family

        The BGP-VPLS address family view is displayed.

      2. Run:

        peer ipv4-address enable

        A peer is specified, and the function to exchange route information with the specified peer is enabled.

Translation
Download
Updated: 2019-08-21

Document ID: EDOC1000142068

Views: 115342

Downloads: 210

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Share
Previous Next