No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


Configuration Guide - VPN

S9300, S9300E, and S9300X V200R010C00

This document describes the VPN configuration procedures and provides configuration examples.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring Route Reflection to Optimize the VPN Backbone Layer

Configuring Route Reflection to Optimize the VPN Backbone Layer

Pre-configuration Tasks

Using an RR can reduce the number of MP IBGP connections between PEs. This not only reduces the burden of PEs, but also facilitates network maintenance and management.

Before configuring route reflection to optimize the VPN backbone layer, complete the following tasks:

  • Configure the routing protocol for the MPLS backbone network to implement IP interworking between devices on the backbone network.

  • Establish LSPs or MPLS TE tunnels between the RR and all client PE devices.

Configuration Process

All the following configuration tasks are mandatory. An RR can be any device such as P, PE, and ASBR.

Updated: 2019-08-21

Document ID: EDOC1000142068

Views: 121144

Downloads: 214

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Previous Next