No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


Configuration Guide - VPN

S9300, S9300E, and S9300X V200R010C00

This document describes the VPN configuration procedures and provides configuration examples.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring Inter-AS PWE3

Configuring Inter-AS PWE3


The devices support inter-AS PWE3 Option A. Option A is easy to implement; however, each ASBR must provide a dedicated interface for each inter-AS VC. The interface can be a sub-interface, physical interface, or logical interface. If the number of inter-AS VCs is small, this solution can be used.

Pre-configuration Tasks

Before configuring inter-AS PWE3, complete the following tasks:

  • Configure an IGP protocol for the MPLS backbone network in each AS to ensure IP connectivity of the backbone network within an AS.

  • Configure basic MPLS functions on the MPLS backbone network in each AS.

  • Configure MPLS LDP and establish the LDP LSP for the MPLS backbone in each AS.


The configurations of inter-AS PWE3 Option A are as follows:

  • Perform the operation of Configuring a Dynamic PW in each AS.
  • Configure the ASBRs. Each ASBR considers the peer ASBR as its CE.

    You do not need to perform any additional configuration for inter-AS implementation on ASBRs and do not need to configure IP addresses for the directly connected interfaces between ASBRs.

The configuration details are not mentioned here.

Checking the Configuration

  • Run the display mpls l2vc [ vc-id | interface interface-type interface-number ] command on the PE to view information about the local PW.

  • Run the display mpls l2vc remote-info [ vc-id ] command on the PE to view information about the remote PW.

Updated: 2019-08-21

Document ID: EDOC1000142068

Views: 119338

Downloads: 212

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Previous Next