No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


Configuration Guide - VPN

S9300, S9300E, and S9300X V200R010C00

This document describes the VPN configuration procedures and provides configuration examples.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring a Dynamic PW

Configuring a Dynamic PW

Pre-configuration Tasks

Before configuring a dynamic PW, complete the following tasks:

  • Configure an Interior Gateway Protocol (IGP) protocol on PEs and Ps on the Multiprotocol Label Switching (MPLS) backbone network to ensure IP connectivity.

  • Configure basic MPLS functions on the backbone network.

  • Set up an LSP tunnel or TE tunnel between the PEs.

    You also need to configure tunnel policies when PWE3 services need to be transmitted over TE tunnels or when PWE3 services need to be load balanced among multiple tunnels to fully use network resources. For details, see step 1 in Configuring and Applying a Tunnel Policy.

  • Set up a remote LDP session between the PEs.

Configuration Process

To configure a dynamic PW, perform the following operations on the device. Creating a PW template and setting attributes for the PW template is optional.

Updated: 2019-08-21

Document ID: EDOC1000142068

Views: 115411

Downloads: 210

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Previous Next