No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


Configuration Guide - VPN

S9300, S9300E, and S9300X V200R010C00

This document describes the VPN configuration procedures and provides configuration examples.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring VPLS PW Redundancy

Configuring VPLS PW Redundancy

Pre-configuration Tasks

Before configuring VPLS PW redundancy, complete the following tasks:

  • Configure IP addresses and an Interior Gateway Protocol (IGP) on PEs.

  • Establish public tunnels between PEs.

    The public tunnels can be:

    • LDP tunnels: To establish LDP tunnels, you must enable MPLS and MPLS LDP globally and in the interface view on each node of the public network. If two PEs are indirectly connected, establish a remote LDP session between them.

    • TE tunnels: To establish TE tunnels, you must enable MPLS, MPLS TE, and RSVP-TE globally and in the interface view on each node of the public network, and enable CSPF in the MPLS view of the ingress of each tunnel to be created.


      Because pseudo wire emulation edge-to-edge (PWE3) uses LDP to distribute VPN labels, you must globally enable MPLS LDP on PEs and establish MPLS LDP sessions if TE tunnels are used as public tunnels.

      If the public tunnels are not LDP tunnels, you must configure tunnel policies and apply them to these public tunnels.

      Only the VPLSs in PWE3 mode support PW redundancy.

  • Enable MPLS L2VPN on PEs.

Figure 6-28  VPLS PW redundancy networking

Configuration Process

To configure VPLS PW Redundancy, perform the following configurations on the PE. Configuring BFD for PW and Manually Switching PWs in a PW Protection Group are optional.

Updated: 2019-08-21

Document ID: EDOC1000142068

Views: 119474

Downloads: 212

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Previous Next