No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - VPN

S9300, S9300E, and S9300X V200R010C00

This document describes the VPN configuration procedures and provides configuration examples.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring VPLS Convergence When the UPE to Directly Connects to the SPE

Configuring VPLS Convergence When the UPE to Directly Connects to the SPE

Pre-configuration Task

Before configuring VPLS convergence, complete the following tasks:
  • Set the LSR ID on the UPE and the SPE, enable MPLS, and create an MPLS LDP session.

  • Enable MPLS L2VPN on the UPE and SPE.

  • Configure the mVRRP and the bind relationships for the mVRRP on the SPE.

  • Configure the mVSI and service VSIs on the UPE.

Configuration Process

NOTE:

switch can function only as a UPE on a VPLS convergence network.

To configure VPLS convergence, perform the following configurations on the UPE. Configuring BFD for VSI PWs is optional. To configure BFD for VSI PWs, you must configure both the SPE and UPE.

Translation
Download
Updated: 2019-08-21

Document ID: EDOC1000142068

Views: 121205

Downloads: 214

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Share
Previous Next