No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


Configuration Guide - VPN

S9300, S9300E, and S9300X V200R010C00

This document describes the VPN configuration procedures and provides configuration examples.

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Resetting Keepalive Packet Statistics on a Tunnel Interface

Resetting Keepalive Packet Statistics on a Tunnel Interface


When you need to calculate and analyze statistics on a tunnel interface, you can reset existing statistics to ensure you can obtain accurate statistics.

After you reset Keepalive packet statistics on a specified tunnel interface, statistics on the number of Keepalive probes and Keepalive reply packets are cleared.

The cleared Keepalive packet statistics cannot be restored. Exercise caution when you run the command.


  1. Run the system-view command to enter the system view.
  2. Run the interface tunnel interface-number command to enter the tunnel interface view.
  3. Run the reset keepalive packets count command to reset Keepalive packet statistics on the tunnel interface.
Updated: 2019-12-31

Document ID: EDOC1000142068

Views: 131379

Downloads: 220

Average rating:
This Document Applies to these Products

Related Version

Related Documents

Previous Next