No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


Log Reference

S9300, S9300E, and S9300X V200R010C00

This document provides the explanations, causes, and recommended actions of logs on the product.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).



CSSM/4/CFGINVALID:Failed to configure CSS port [OCTET], and the port may be unavailable. Please reset slot [OCTET] and configure the CSS port again.


An error occurred when a user attempted to configure service ports as physical member ports of a CSS port. The service ports became unavailable.


Parameter Name Parameter Meaning
port [OCTET] Indicates the number of the CSS port.
slot [OCTET] Indicates the sot ID of the service ports that failed to be configured as physical member ports.

Possible Causes

An active/standby switchover occurred or the master MPU was removed before the CSS port configuration was complete.


  1. Run the port interface enable command again to configure service ports as physical member ports again.
    • If the configuration succeeds, no action is required.
    • If the configuration fails, go to step 2.
  2. Run the reset slot command to reset the corresponding card and then configure service ports as physical member ports.
    • If the configuration succeeds, no action is required.
    • If the configuration fails, collect log information and configuration information, and then contact technical support personnel.You can collect diagnostic information using the display diagnostic-information command.
Updated: 2019-08-21

Document ID: EDOC1000142069

Views: 546127

Downloads: 37

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Previous Next