No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


Log Reference

S9300, S9300E, and S9300X V200R010C00

This document provides the explanations, causes, and recommended actions of logs on the product.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).



MPLS/4/RPC_CALL_FAIL: RPC Call failed. (Service=[STRING] SlotID=[ULONG] Error Code=[ULONG])


The MPLS module failed to invoke a remote procedure call (RPC).


Parameter Name Parameter Meaning
Service Indicates the RPC invoking module.
SlotID Indicates the slot ID.
Error Code Indicates the error code.

Possible Causes

The RPC module failed to send messages.


  1. Run the display device command to check whether the LPU has registered.

    • If so, go to step 3.
    • If not, go to step 2.

  2. If the LPU has not registered, RPC communication fails, which is normal. This log is informational only, and no action is required.
  3. Collect log information and configuration information, and then contact technical support personnel.You can collect diagnostic information using the display diagnostic-information command.
Updated: 2019-08-21

Document ID: EDOC1000142069

Views: 548387

Downloads: 37

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Previous Next