No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Log Reference

S9300, S9300E, and S9300X V200R010C00

This document provides the explanations, causes, and recommended actions of logs on the product.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
MPLS/4/L2VPN_ADD_VPTBL

MPLS/4/L2VPN_ADD_VPTBL

Message

MPLS/4/L2VPN_ADD_VPTBL: Add source_vp table failed when create forwarding entry for l2vpn [ULONG].

Description

The device failed to deliver the VP index. The VP index is allocated by the software to control L2VPN resources.

Parameters

Parameter Name Parameter Meaning
ULONG Indicates the VP index.

Possible Causes

The number of VP indexes exceeds the maximum number of VPs supported by the card.

Procedure

  1. Run the display mpls l2vpn resource commands to check L2VPN services that consume many resources.
  2. Run the display current-configuration command to check detailed device configuration. Delete unnecessary L2VPN services.
  3. Run the display mpls l2vpn resource command to check there are available resources. If so, the problem is rectified.
  4. When many VSIs are configured on the device and a large number of interfaces are added to the VLANs bound to the VSIs, VP index resources may be insufficient. Remove unnecessary interfaces from the VLAN bound to a VSI. If the problem persists, go to step 5.
  5. Collect log information and configuration information, and then contact technical support personnel.You can collect diagnostic information using the display diagnostic-information command.
Translation
Download
Updated: 2019-08-21

Document ID: EDOC1000142069

Views: 550107

Downloads: 37

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Share
Previous Next