No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Log Reference

S9300, S9300E, and S9300X V200R010C00

This document provides the explanations, causes, and recommended actions of logs on the product.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
ALML/4/HG_STATE

ALML/4/HG_STATE

Message

ALML/4/HG_STATE: Higig port state has changed. (SlotID=[STRING1], UnitID=[INTEGER], PortID=[STRING2] has turned into [STRING3] state, PeerSlotID=[STRING4].)

Description

Port state of the HG channel changed.

Parameters

Parameter Name Parameter Meaning
SlotID Indicates the slot ID.
UnitID Indicates the chip ID.
PortID Indicates the port number of the HG channel.
STRING3 Indicates the port state of the HG channel.
PeerSlotID Indicates the slot ID of the remote card.

Possible Causes

  • The local or remote card is not securely installed.
  • The local or remote card connector is faulty.
  • The local or remote card is faulty.

Procedure

  1. Check whether the local and remote cards are securely installed.
    • If so, go to step 2.
    • If not, install these cards securely.
  2. Remove the local and remote cards to check whether there are bent pins on the backplane and connector.
    • If so, go to step 4.
    • If not, go to step 3.
  3. Replace the cards and check whether this log persists.
    • If so, go to step 4.
    • If not, the alarm handling ends.
  4. Collect log information and configuration information, and then contact technical support personnel.You can collect diagnostic information using the display diagnostic-information command.
Translation
Download
Updated: 2019-08-21

Document ID: EDOC1000142069

Views: 550222

Downloads: 37

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Share
Previous Next