No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


Log Reference

S9300, S9300E, and S9300X V200R010C00

This document provides the explanations, causes, and recommended actions of logs on the product.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).



ALML/4/ENT_PULL_OUT:[STRING] was pulled out.


A board or a subcard is removed.


Parameter Name Parameter Meaning
STRING Information about the removed entity. For example, describe information about a board through the board name, board type, or board slot ID.

Possible Causes

  • A board or a subcard is removed manually.
  • The connection between a board or a subcard and the slot is loose.


  1. Run the display device command to check whether the subcard or board is installed properly.
    • If so, collect log information and configuration information, and then contact technical support personnel.You can collect diagnostic information using the display diagnostic-information command.
    • If not, go to step 2.
  2. Check whether the subcard or board is removed manually.
    • If so, no action is required.
    • If not, install the subcard or board again.
Updated: 2019-08-21

Document ID: EDOC1000142069

Views: 553824

Downloads: 37

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Previous Next