No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Log Reference

S9300, S9300E, and S9300X V200R010C00

This document provides the explanations, causes, and recommended actions of logs on the product.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
APS/7/PKT_PLAT_TO_PPI

APS/7/PKT_PLAT_TO_PPI

Message

APS/7/PKT_PLAT_TO_PPI:Plat send packet templet to adapter failed.(ModuleID=[ULONG], ProtectionID=[ULONG], APSFastSndInterval=[ULONG], WtrTime=[ULONG], HoldOffTimeInterval=[ULONG], ProtectionEnable=[ULONG], APSPktFlag=[ULONG], ProtectionMode=[ULONG], ProtectionDirection=[ULONG], RevertiveMode=[ULONG], LocalState=[ULONG], GlobalState=[ULONG], APSState=[ULONG], LocalSelector=[ULONG], LocalBridge=[ULONG], SwitchCommand=[ULONG], WorkingLinkState=[ULONG], ProtectionLinkState=[ULONG], ProtectionProtocol=[ULONG], StatusSlot=[STRING], WorkingLinkManageState=[ULONG], ProtectionLinkManageState=[ULONG], ErrorCode=[ULONG])

Description

After finishing status calculation, the APS state machine sent the packet template to the device. If the sending failed, the information about the packet template was recorded for later analysis.

Parameters

Parameter Name Parameter Meaning
ModuleID Indicates the index of a module.
ProtectionID Indicates the index of a protection group.
APSFastSndInterval Indicates the interval for fast sending packets.
WtrTime Indicates the wait-to-restore time.
HoldOffTimeInterval Indicates the hold-off time.
ProtectionEnable Indicates the flag bit for enabling the protection.
APSPktFlag Indicates the flag bit for enabling packets.
ProtectionMode Indicates the protection mode.
ProtectionDirection Indicates the protection direction.
RevertiveMode Indicates the revertive mode.
LocalState Indicates the local status.
GlobalState Indicates the global status.
APSState Indicates the status of APS packets.
LocalSelector Indicates the local tunnel for selecting and receiving services.
LocalBridge Indicates the local tunnel for sending services.
SwitchCommand Indicates the local manual commands.
WorkingLinkState Indicates the status of the local working link.
ProtectionLinkState Indicates the status of the local protection link.
ProtectionProtocol Indicates the protection protocol.
StatusSlot Indicates the slot where the state machine is located.
WorkingLinkManageState Indicates the management state of the local working link.
ProtectionLinkManageState Indicates the management state of the local protection link.
ErrorCode Indicates an error code.

Possible Causes

The S9300, S9300E, and S9300X failed to send information about the packet template to the device.

Procedure

  1. Collect log information and configuration information, and then contact technical support personnel.
Translation
Download
Updated: 2019-08-21

Document ID: EDOC1000142069

Views: 569144

Downloads: 37

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Share
Previous Next