No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Log Reference

S9300, S9300E, and S9300X V200R010C00

This document provides the explanations, causes, and recommended actions of logs on the product.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
LOAD/6/LOAD_RESULT

LOAD/6/LOAD_RESULT

Message

  1. LOAD/6/LOAD_RESULT: [slot-name] number of files exceed 31.
  2. LOAD/6/LOAD_RESULT: Software has been successfully downloaded to [slot-name].
  3. LOAD/6/LOAD_RESULT: Download of software to [slot-name] has occurred [errcode].
  4. LOAD/6/LOAD_RESULT: [slot-name] is reset or power off or pulled out when loading.

Description

  1. The number of files that need to be loaded from an MPU to the specified card exceeded 31.
  2. Software has been downloaded to the specified card.
  3. An error occurred during software download on the specified card and the error code was displayed.
  4. The specified card was reset, powered off, or removed during file load.

Parameters

Parameter Name Parameter Meaning
slot-name Indicates the slot ID involved in this log.

Possible Causes

  1. The number of files to be loaded exceeded 31.
  2. Software has been successfully downloaded.
  3. The error code was displayed in the log.
  4. The current card was reset, powered off, or removed.

Procedure

  • For cause 1: The number of loaded files is recorded incorrectly. If the fault persists after a restart, contact engineers.
  • For cause 2: No action is required.
  • For cause 3: Check diagnostic logs on the device and rectify the fault accordingly.
  • For cause 4: Check whether the current card is installed properly. If so, check whether the card is reset. After this card is registered again, check the reset cause.
Translation
Download
Updated: 2019-08-21

Document ID: EDOC1000142069

Views: 577868

Downloads: 37

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Share
Previous Next