No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Log Reference

S9300, S9300E, and S9300X V200R010C00

This document provides the explanations, causes, and recommended actions of logs on the product.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
SW_SNPG/3/OVER_INDEX

SW_SNPG/3/OVER_INDEX

Message

SW_SNPG/3/OVER_INDEX: The IPMC index is out of the index range on the board. (VLAN=[ULONG], source=[STRING], group=[STRING], index=[ULONG], max index=[ULONG], index type=[ULONG])

Description

The L2MC index is beyond the index range on the LPU.

Parameters

Parameter Name Parameter Meaning
VLAN Indicates a VLAN ID.
source Indicates the IP address of a multicast source.
group Indicates a multicast group address.
index Indicates the current L2MC index.
max index Indicates the maximum index value.
index type Indicates the index type.

Possible Causes

The number of L2MC indexes has exceeded the upper limit.

Procedure

  1. Perform following operations for different types of multicast forwarding entries:

    • For dynamic Layer 2 multicast forwarding entries, run the display igmp-snooping port-info or display mld-snooping port-info command to check whether there are too many IPv4 or IPv6 Layer 2 multicast forwarding entries for IP address-based forwarding. If so, run the reset igmp-snooping group { all | vlan { all | vlan-id [ [ source-address source-address ] group-address group-address ] } } or reset mld-snooping group { all | vlan vlan-id [ [ source-address source-ipv6-address ] group-address group-ipv6-address ] } command to delete unnecessary IPv4 or IPv6 entries.
    • For static Layer 2 multicast forwarding entries, run the undo l2-multicast static-group [ source-address source-ip-address ] group-address group-ip-address vlan { all | { vlan-id1 [ to vlan-id2 ] } &<1-10> } command in the interface view to delete the static group configuration.

  2. Re-configure multicast services. If this log persists, go to step 3.
  3. Collect log information and configuration information, and then contact technical support personnel. You can collect diagnostic information using the display diagnostic-information command.
Translation
Download
Updated: 2019-08-21

Document ID: EDOC1000142069

Views: 540159

Downloads: 37

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next