No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


Log Reference

S9300, S9300E, and S9300X V200R010C00

This document provides the explanations, causes, and recommended actions of logs on the product.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).



MRM/3/BACKUPSOCKET_E:In VPN instance "[vpn-instance-name]", MRM failed to backup [protocol-name] socket ID [socket-id]. The error code was [error-code].(FlCode=[STRING][ULONG])


The MRM module on the main control board failed to back up the socket ID.


Parameter Name Parameter Meaning
[vpn-instance-name] Indicates the name of a VPN instance.
[protocol-name] Indicates the name of the protocol. The value can be:
  • GMP
  • PIM
[socket-id] Indicates the socket ID.
[error-code] Indicates the error code. The value can be:
  • 0: The value is successfully returned.

  • 1: The main control board in use is not the master one.

  • 2: The slave main control board does not exist.

  • 3: Fail to allocate memory.

  • 4: Fail to write data to the buffer.

  • 5: Fail to access data from the buffer.

  • 6: Fail to send messages.

  • 7: The backup is canceled

FlCode Indicates the name of the source code file and the line number of this log message.

Possible Causes


Communication fails, and the socket ID cannot be backed up normally.


Programs or cooperative programs are processed abnormally.


  1. Restart the slave board.
  2. Run the undo multicast routing-enable command or the undo multicast ipv6 routing-enable command to delete multicast configurations, and then reconfigure related multicast commands.
Updated: 2019-08-21

Document ID: EDOC1000142069

Views: 568888

Downloads: 37

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Previous Next