No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.

S12700 V200R010C00 Configuration Guide - Device Management

This document describes the principles and configurations of the Device Management features, and provides configuration examples of these features.

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring PTP on an OC

Configuring PTP on an OC

OC Deployment

As shown in Figure 5-9, when two devices transmit wireless data on the IP bearer network, low-delay transmission must be guaranteed for real-time wireless services. As OCs, the two devices transmit clock information through PTP messages to ensure clock synchronization between them. OCs can provide a high-precision clock source for devices in a PTP domain using the Building Integrated Timing Supply (BITS) system.

Figure 5-9  Configuring PTP on an OC

Pre-configuration Tasks

Before configuring PTP on an OC, complete the following tasks:

  • Set link layer protocol parameters for interfaces to ensure that the link layer protocol status of the interfaces is Up.

  • Configure a grandmaster clock to correctly obtain clock and time signals from the BITS device.

Configuration Process

The process of configuring PTP on an OC is as follows.

Updated: 2019-12-28

Document ID: EDOC1000142080

Views: 140759

Downloads: 161

Average rating:
This Document Applies to these Products

Related Version

Related Documents

Previous Next