No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

S12700 V200R010C00 Configuration Guide - Device Management

This document describes the principles and configurations of the Device Management features, and provides configuration examples of these features.

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring Services for an AS

Configuring Services for an AS

Context

In an SVF system, two AS service configuration modes are available: centralized mode and independent mode. The two modes cannot be used on the same AS.

  • In centralized mode, all service configurations for ASs are performed on the parent. Therefore, which services can be configured on ASs depends on the services that can be configured on the parent, but not depend on the services supported by a standalone access switch. The centralized mode is classified into three modes:

    • Global configuration

      Configure service functions in the uni-mng view of the parent (except that authentication-free rules need to be configured in the system view), and then run the commit as { name as-name | all } command to deliver AS service configurations. This mode supports few configurations.

    • Profile-based configuration

      Create service profiles and specified device and port groups on the parent, bind the service profiles to the device and port groups, and then run the commit as { name as-name | all } command to deliver AS service configurations. If multiple ASs or ports in an SVF system need the same configurations, you can add these ASs or ports to the same group for batch configuration. This improves the configuration efficiency.

    • Direct configuration

      Run the direct-command command on the parent to directly deliver configurations to an AS. These configurations will take effect on the AS immediately.

  • In independent mode, you can log in to an AS to configure services on the AS using commands. After the configuration is complete, you can run the upload config command to save the configuration file to the AS and upload it to the parent.

    The independent mode supports more service configurations than the centralized mode. When services cannot be batch configured on the parent for an AS, log in to the AS to configure this AS independently. After the AS changes from the centralized mode to independent mode, all the service configurations performed using profiles or directly delivered before mode switching will be retained.

Translation
Download
Updated: 2019-12-28

Document ID: EDOC1000142080

Views: 123105

Downloads: 155

Average rating:
This Document Applies to these Products

Related Version

Related Documents

Share
Previous Next