No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


S12700 V200R010C00 Configuration Guide - Device Management

This document describes the principles and configurations of the Device Management features, and provides configuration examples of these features.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Setting the WTR Time of a Clock Source

Setting the WTR Time of a Clock Source


Setting the WTR time of a clock source can avoid some mistakes in determining the clock source caused by occasional signal jitter on the network. The default WTR time of a clock source is 1 minute. Generally, you do not need to change the default value. If you want to see the clock source switching result during debugging, set the WTR time to 0.


  1. Run:


    The system view is displayed.

  2. Run:

    clock wait-to-restore wait-to-restore-time source source

    The wait-to-restore (WTR) time of a clock source is set.

    By default, the WTR time of a clock source is 1 minute.

Updated: 2019-08-21

Document ID: EDOC1000142080

Views: 108686

Downloads: 144

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Previous Next