No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

S12700 V200R010C00 Configuration Guide - Device Management

This document describes the principles and configurations of the Device Management features, and provides configuration examples of these features.

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Applications

Applications

PTP Application on a Transmission Network

Most of the time-division multiplexing (TDM) service on a traditional fixed network is the voice service. If the clocks on two ends of the transmission network are different, the accumulated difference between the clocks will cause clock slip. In Figure 5-7, an ordinary clock (OC) device encapsulates high-precision clock information obtained through the GPS into a PTP message and sends the PTP message to a boundary clock (BC) device on the transmission network. Core devices on the transmission network function as transparent clock (TC) devices to transparently transmit the clock information to the entire transmission network. Then the edge devices of the transmission network function as BC devices to provide the high-precision clock information obtained through the PTP message to wireless access devices, such as NodeB and radio network controller (RNC).

Figure 5-7  Application of PTP on a transmission network

Network Protection

PTP supports protective switchover between devices and between components on the same device to prevent single-point failures. In Figure 5-8, the solid lines identify the primary clock tracing path. The time source is provided by GPS-1 and is transmitted to the lower layers in the direction shown by the blue arrows. The dashed lines identify the protection path. When the primary path is faulty, GPS-2 can replace GPS-1 to provide the time source rapidly.

Figure 5-8  Protective switchover on the time synchronization network

Translation
Download
Updated: 2019-12-28

Document ID: EDOC1000142080

Views: 123792

Downloads: 155

Average rating:
This Document Applies to these Products

Related Version

Related Documents

Share
Previous Next