No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

S12700 V200R010C00 Configuration Guide - Device Management

This document describes the principles and configurations of the Device Management features, and provides configuration examples of these features.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Setting Mode of a BITS Clock

Setting Mode of a BITS Clock

Context

The BITS clock refers to the clock signal sent from the BITS interface to a network element. The signal would be clock signal or time signal. The signal that a BITS clock receives depends on the signal that the BITS interface sends and receives.

NOTE:

Interconnected devices must use the same transmission mode of the BITS clock.

Procedure

  1. Run:

    system-view

    The system view is displayed.

  2. Run:

    clock bits-type { bps-2m | hz-2m | bps-1544m } { bits0 | bits1 }

    The clock mode is set for the BITS0 or BITS1 clock.

    Or run:
    clock bits-type { dcls-time | 1pps-tod } { in | out } { bits0 | bits1 }

    The time mode is set for the BITS0 or BITS1 clock.

    By default, the BITS clocks adopt the bps-2m mode.

Translation
Download
Updated: 2019-08-21

Document ID: EDOC1000142080

Views: 108149

Downloads: 141

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Share
Previous Next