No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


S12700 V200R010C00 Configuration Guide - Device Management

This document describes the principles and configurations of the Device Management features, and provides configuration examples of these features.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Resetting a Card

Resetting a Card


When an LPU needs to be upgraded or cannot work normally, you can reset the LPU to update the version or restore the LPU to the normal state.

Resetting a card interrupts services on it. When a card is not working normally, rectify the fault rather than reset the card to prevent services from being affected.


  1. (Optional) Run:

    display device [ slot slot-id ]

    The card status is displayed.

  2. Run:

    reset slot slot-id [ all | master ]

    The card is reset.

    The all and master parameters are displayed in the command if slot-id specifies an NGFW, ACU2, or IPS card.

    An NGFW, ACU2, or IPS card has two CPUs: one for the value-added service and one for the switching service. If you specify all, both CPUs are reset. If you specify master, the CPU of the value-added service is reset.

Updated: 2019-08-21

Document ID: EDOC1000142080

Views: 109551

Downloads: 144

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Previous Next