No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


S12700 V200R010C00 Configuration Guide - Device Management

This document describes the principles and configurations of the Device Management features, and provides configuration examples of these features.

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Splitting a CSS

Splitting a CSS


If the current CSS system no longer transmits services, you can split the CSS into standalone switches.

The procedure for splitting a CSS is as follows:

  1. Back up the CSS configuration file.

  2. Delete the system MAC address of the CSS if configured.

  3. Disable the CSS function.

  4. Power off the switches and remove the cluster cables.


  1. Back up the configuration file.

    1. Run the save command to save the configuration.
    2. Run the copy source-filename destination-filename all command to back up the configuration file to the standby switch.

    Back up the current configuration file to the storage medium of the standby switch before you split the CSS. You can use the configuration file when you set up a CSS next time.

  2. Delete the system MAC address of the CSS.

    1. Run the system-view command to enter the system view.
    2. Run the undo set css system-mac command to delete the system MAC address of the CSS.

  3. Disable the CSS function.

    Run the undo css enable all command to disable the CSS function on two member switches. The switches restore to standalone switches after they restart.

  4. Power off the switches and remove the cluster cables.

    You can also remove the cluster cables when the switches are running.

Updated: 2019-12-28

Document ID: EDOC1000142080

Views: 123167

Downloads: 155

Average rating:
This Document Applies to these Products

Related Version

Related Documents

Previous Next