Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document.
Note: Even the most advanced machine translation cannot match the quality of professional translators.
Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring Link Aggregation in LACP Mode
Link aggregation implements load balancing, increases bandwidth, and improves transmission reliability.
- (Optional) Setting the Maximum Number of LAGs and the Maximum Number of Member Interfaces in Each LAG
- Creating an LAG
- Setting the LACP Mode
- Adding Member Interfaces to an Eth-Trunk
- (Optional) Setting the Upper and Lower Thresholds for the Number
of Active Interfaces
- (Optional) Configuring a Load Balancing Mode
- (Optional) Setting the LACP System Priority
- (Optional) Setting the LACP Interface Priority
- (Optional) Configuring LACP Preemption
- (Optional) Setting the Timeout Interval for Receiving LACPDUs
- (Optional) Configuring an Eth-Trunk Member Interface on a Switch
Directly Connected to a Server to Forward Packets
- Checking the Configuration