No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


S12700 V200R010C00 Configuration Guide - Ethernet Switching

This document describes the configuration of Ethernet services, including configuring link aggregation, VLANs, Voice VLAN, VLAN mapping, QinQ, GVRP, MAC table, STP/RSTP/MSTP, SEP, and so on.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
(Optional) Disabling Revertive Switching on an E-Trunk

(Optional) Disabling Revertive Switching on an E-Trunk


You can disable revertive switching on an E-Trunk to prevent traffic from being discarded when a faulty master device recovers and takes over services.


  1. Run:


    The system view is displayed.

  2. Run:

    e-trunk e-trunk-id

    The E-Trunk view is displayed.

  3. Run:

    revert disable

    Revertive switching is disabled on the E-Trunk.

    By default, revertive switching is enabled on an E-Trunk.

Updated: 2019-08-21

Document ID: EDOC1000142081

Views: 260561

Downloads: 412

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Previous Next