No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


S12700 V200R010C00 Configuration Guide - Ethernet Switching

This document describes the configuration of Ethernet services, including configuring link aggregation, VLANs, Voice VLAN, VLAN mapping, QinQ, GVRP, MAC table, STP/RSTP/MSTP, SEP, and so on.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Switches Connected Across a Transmission Device Through Link Aggregation

Switches Connected Across a Transmission Device Through Link Aggregation

In Figure 3-14, a transmission device needs to be deployed between two switches that are far away from each other to ensure reliable communication. In addition, link aggregation is configured between the two switches to enhance link bandwidth and reliability.

  • The switches at both ends must use link aggregation in LACP mode.
  • The transmission device between switches must be configured to transparently transmit LACPDUs.
Figure 3-14  Switches connected across a transmission device through link aggregation
Updated: 2019-08-21

Document ID: EDOC1000142081

Views: 272679

Downloads: 420

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Previous Next