No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

S12700 V200R010C00 Configuration Guide - Ethernet Switching

This document describes the configuration of Ethernet services, including configuring link aggregation, VLANs, Voice VLAN, VLAN mapping, QinQ, GVRP, MAC table, STP/RSTP/MSTP, SEP, and so on.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring L3VPN

Configuring L3VPN

After a QinQ termination sub-interface is configured, you need to configure the VPN service so that users at both ends of the L3VPN can communicate with each other.

Configure L3VPN on the CE, PE, and P. For details, see BGP/MPLS IP VPN Configuration or BGP/MPLS IPv6 VPN Configuration in the S12700 V200R010C00 Configuration Guide - VPN.

Translation
Download
Updated: 2019-08-21

Document ID: EDOC1000142081

Views: 272654

Downloads: 420

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Share
Previous Next