Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document.
Note: Even the most advanced machine translation cannot match the quality of professional translators.
Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Checking the Configuration
Procedure
- Run the display loop-detection [ interface interface-type interface-number ] command to check the LDT configuration
and interface status.
If interface-type and interface-number are not specified, the status of the global LDT function is displayed. If the function is enabled, the system displays the interval for sending LDT packets, ID of the VLANs with this function enabled, detected loops, and actions taken on the interfaces where loops are detected.
If interface-type and interface-number are specified, the system displays the interface status, interface recovery time, and LDT-enabled VLAN.
Previous
