Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document.
Note: Even the most advanced machine translation cannot match the quality of professional translators.
Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Checking the Configuration
Procedure
- Run the display eth-trunk [ trunk-id [ interface interface-type interface-number | verbose ] ] command to check the Eth-Trunk configuration.
- Run the display trunkmembership eth-trunk trunk-id command to check information about Eth-Trunk member interfaces.
- Run the display eth-trunk [ trunk-id ] load-balance command to check the load balancing mode of the Eth-Trunk.
- Run the display load-balance-profile [ profile-name ] command to check the load balancing profile of the Eth-Trunk.
- Run the display trunk configuration command to check the maximum number of LAGs and the maximum number of member interfaces in each LAG.