Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document.
Note: Even the most advanced machine translation cannot match the quality of professional translators.
Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring an E-Trunk
The Enhanced Trunk (E-Trunk) protocol implements link aggregation between multiple devices to improve link reliability between devices. It is an extension to LACP which only implements link aggregation on a single device.
- Setting the LACP System ID and LACP Priority of an E-Trunk
- Creating an E-Trunk and Setting the E-Trunk Priority
- Configuring Local and Remote IP Addresses of an E-Trunk
- Binding an E-Trunk to a BFD Session
- Adding an Eth-Trunk to an E-Trunk
- (Optional) Configuring the Working Mode of an Eth-Trunk in
an E-Trunk
- (Optional) Setting the Password for Encrypting Packets
- (Optional) Setting the Timeout Interval of Hello Packets
- (Optional) Setting the Revertive Switching Delay
- (Optional) Disabling Revertive Switching on an E-Trunk
- (Optional) Configuring the E-Trunk Sequence Number Check Function
- Checking the Configuration
Previous
