No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


S12700 V200R010C00 Configuration Guide - Ethernet Switching

This document describes the configuration of Ethernet services, including configuring link aggregation, VLANs, Voice VLAN, VLAN mapping, QinQ, GVRP, MAC table, STP/RSTP/MSTP, SEP, and so on.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
ERPS Multi-instance

ERPS Multi-instance

On a common ERPS network, a physical ring can be configured with a single ERPS ring, and only one blocked port can be specified in the ring. When the ERPS ring is in normal state, the blocked port prohibits all service packets from passing through. As a result, all service data is transmitted through one path over the ERPS ring, and the other link on the blocked port becomes idle, wasting bandwidth. As shown in Figure 19-13, when only ERPS Ring1 is configured, Interface1 is blocked and data is forwarded through the path where Data Flow1 travels. The link SwitchC -> SwitchD -> SwitchE is idle.

Figure 19-13  Networking diagram of ERPS multi-instance

To improve link use efficiency, only two logical rings can be configured in the same physical ring in the ERPS multi-instance. A port may have different roles in different ERPS rings and different ERPS rings use different control VLANs. A physical ring can have two blocked ports accordingly. Each blocked port independently monitors the physical ring status and is blocked or unblocked. An ERPS ring must be configured with an ERP instance, and each ERP instance specifies a range of VLANs. The topology calculated for a specific ERPS ring only takes effect in the ERPS ring. Different VLANs can use separate paths, implementing traffic load balancing and link backup.

As shown in Figure 19-13, you can configure ERPS Ring1 and ERPS Ring2 in the physical ring consisting of SwitchA through SwitchE. Interface1 is the blocked port in ERPS Ring1. The VLANs mapping to the ERP instance is VLANs 100 to 200. Interface2 is the blocked port in ERPS Ring2. The VLANs mapping to the ERP instance is VLANs 300 to 400. After the configuration is completed, data from VLANs 100 to 200 is forwarded through Data Flow1, and data from VLANs 300 to 400 is forwarded through Data Flow2. In this manner, load balancing is implemented and link use efficiency is improved.

Updated: 2019-08-21

Document ID: EDOC1000142081

Views: 268865

Downloads: 414

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Previous Next