No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

S12700 V200R010C00 Configuration Guide - Ethernet Switching

This document describes the configuration of Ethernet services, including configuring link aggregation, VLANs, Voice VLAN, VLAN mapping, QinQ, GVRP, MAC table, STP/RSTP/MSTP, SEP, and so on.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Creating an LAG

Creating an LAG

Context

Each LAG corresponds to an Eth-Trunk. Before configuring link aggregation, create an Eth-Trunk.

Procedure

  1. Run:

    system-view

    The system view is displayed.

  2. Run:

    interface eth-trunk trunk-id

    An Eth-Trunk is created and the Eth-Trunk interface view is displayed.

    The value of trunk-id ranges from 0 to 127.

    If the device is equipped with cards specified in the assign trunk command, you can run the assign trunk command to set the value, and run the display trunk configuration command to view the configuration.

    If the specified Eth-Trunk already exists, this command directly displays the Eth-Trunk interface view.

Translation
Download
Updated: 2019-08-21

Document ID: EDOC1000142081

Views: 260728

Downloads: 412

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Share
Previous Next