No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

S12700 V200R010C00 Configuration Guide - Ethernet Switching

This document describes the configuration of Ethernet services, including configuring link aggregation, VLANs, Voice VLAN, VLAN mapping, QinQ, GVRP, MAC table, STP/RSTP/MSTP, SEP, and so on.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
What Is the Function of the Delay for LACP Preemption?

What Is the Function of the Delay for LACP Preemption?

When an Eth-Trunk interface in LACP mode goes Up and Down frequently due to unstable physical links, LACP goes Up and Down accordingly. As a result, services transmitted on the Eth-Trunk link are affected. After the LACP preemption delay is set, LACP negotiation is not performed during the delay period. The possibility of LACP flapping is reduced, and services will not be affected.

You can run the lacp preempt enable command to enable the LACP preemption function on the current Eth-Trunk interface and run the lacp preempt delay delay-time command to configure the preemption delay.

Translation
Download
Updated: 2019-08-21

Document ID: EDOC1000142081

Views: 268950

Downloads: 416

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Share
Previous Next