No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


S12700 V200R010C00 Configuration Guide - Ethernet Switching

This document describes the configuration of Ethernet services, including configuring link aggregation, VLANs, Voice VLAN, VLAN mapping, QinQ, GVRP, MAC table, STP/RSTP/MSTP, SEP, and so on.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Licensing Requirements and Limitations for STP/RSTP

Licensing Requirements and Limitations for STP/RSTP

Involved Network Elements

Other network elements also need to support STP or RSTP.

Licensing Requirements

STP or RSTP is a basic feature of a switch and is not under license control.

Version Requirements

Table 14-13  Products and versions supporting STP or RSTP


Product Model

Software Version


S12708, S12712

V200R005C00, V200R006C00, V200R007C00, V200R007C20, V200R008C00, V200R009C00, V200R010C00, V200R011C10


V200R010C00, V200R011C10


V200R008C00, V200R009C00, V200R010C00, V200R011C10

To know details about software mappings, see Hardware Query Tool.

Feature Limitations

When STP or RSTP is enabled on a ring network, STP or RSTP immediately starts spanning tree calculation. Parameters such as the device priority and port priority affect spanning tree calculation, and the change of these parameters may cause network flapping. To ensure fast and stable spanning tree calculation, configure parameters such as the device priority and port priority before enabling STP or RSTP.

On a switch enabled with a spanning tree protocol, when a terminal connects to the switch, spanning tree calculation is performed again. As a result, it takes a long period of time for the terminal to obtain an IP address. In this case, disable the spanning tree protocol on the switch port connected to the terminal or configure this switch port as the edge port.

Updated: 2019-08-21

Document ID: EDOC1000142081

Views: 258827

Downloads: 408

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Previous Next