Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document.
Note: Even the most advanced machine translation cannot match the quality of professional translators.
Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
How to Prevent Low Convergence for STP Edge Ports that Connect Terminals?
Terminal devices cannot participate in the STP calculation or respond to STP packets, causing low convergence. You can prevent low convergence for STP edge switch ports for connecting user terminals or servers as follows:
- On a port, run the stp edge-port enable command to configure the port as an STP edge port, and run the stp bpdu-filter enable command to enable the BPDU packet filtering function and prevent the port from sending BPDU packets.
- Run the stp disable command on the port to disable the STP protocol and make the port remain in forwarding state.