No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

S12700 V200R010C00 Configuration Guide - Ethernet Switching

This document describes the configuration of Ethernet services, including configuring link aggregation, VLANs, Voice VLAN, VLAN mapping, QinQ, GVRP, MAC table, STP/RSTP/MSTP, SEP, and so on.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring Interface-based Layer 2 Protocol Transparent Transmission

Configuring Interface-based Layer 2 Protocol Transparent Transmission

When each interface of a backbone device is connected to only one user network and Layer 2 protocol packets sent from the user network do not need VLAN tags, configure interface-based Layer 2 protocol transparent transmission on the interface connected to the user network. This configuration allows Layer 2 protocol packets to be transparently transmitted on the backbone network.

Pre-configuration Tasks

Before configuring interface-based Layer 2 protocol transparent transmission, complete the following task:
  • Set link layer protocol parameters and IP addresses for interfaces to ensure that the link layer protocol on the interfaces is Up.
Translation
Download
Updated: 2019-08-21

Document ID: EDOC1000142081

Views: 260257

Downloads: 412

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Share
Previous Next